NECO TX4 REMOTE CONTROL HAND SET FOR ROLLER SHUTTER HAND SET KEY FOB TRANSMITTER 433MHZ GARAGE DOORS

NECO TX4 REMOTE CONTROL HAND SET FOR ROLLER SHUTTER HAND SET KEY FOB TRANSMITTER 433MHZ GARAGE DOORS

NECO TX4 REMOTE CONTROL CLONE DUPLICATOR

Features:

Single Channel
Fitted with Replaceable Long Life Lithium Battery
Up / Stop / Down Buttons
Front Sliding cover to prevent accidental operation of the shutter
Chrome Finish
Keyfob clip

Product Codes:

NT1016 is Compatible with all NVM Controllers NT1004, NT1006, NT1103 v2, NT1008, NT1019, NT1105
Compatible with NT1103 v2+ supplied after May 2012.

Please check installation date before ordering this product if using NT1103.

Technical Specifications:

Channels: Single Channel
Frequency: 433mHz
Random Codes: 5 million



It is a copy replacement for the Neco TX4 Old (With Grey Buttons)


Frequency. 433Mhz

Batteries 1 x 27a 12v

Dimension L 6cm W 3.3cm

Additional EPZ10002 EPS10002




How to program NECO MK1 NEW remote control


Please note:

If you keep the programming button of your receiver pressed down too long, you will erase the programming code of all your already programmed remote controls.

Programming of your new remote control:


Open the casing of your receiver located next to your motor. On the receiver board, press the programming button and let it go (ENR, MEMO, PROG, REC) according to the model.


When the LED light on the receiver illuminates or blinks. Press a button on your new remote control for 1 second.


Let the button go. The LED light on the receiver turns off immediately or in the following 10 seconds.


Your new remote control is programmed.



All of our Neco gate and garage door remote controls come complete with batteries and full step by step programming instructions.

We stock a full range of Neco replacement remote controls and gate or key fobs that can be used for controlling all types of electric gates and electric garage door openers.

Please give us a call if you need advice on which remote transmitter to purchase.




Frequently Asked Questions about this product


Is it possible to clone/copy this new remote control with an existing one

No it is not possible.

The remote control has a fixed code type encoding in order to ensure high security and prevent unauthorized copying.


In this case, you have to do the configuration from inside the control panel, with the receiver only




NECO TX4 REMOTE CONTROL HAND SET FOR ROLLER SHUTTER HAND SET KEY FOB TRANSMITTER 433MHZ GARAGE DOORS